ZOLL AED Plus Replacement Lithium Batteries – Duracell 10-Pack (8000-0807-01)

Is Your ZOLL AED Plus Beeping or Showing a Red “X”?

If your ZOLL AED Plus is chirping or displaying a red “X” in the status indicator window, your batteries have reached the end of their operational life. To ensure your defibrillator is ready to deliver a life-saving shock during a sudden cardiac arrest emergency, replace all 10 batteries immediately.

Why Brand Specification Matters

The ZOLL AED Plus internal monitoring circuitry and self-test algorithms are calibrated specifically for Duracell Type 123 Lithium Manganese Dioxide (LiMnO2) batteries. Using off-brand, uncertified, or rechargeable lithium cells can cause self-test failures, inaccurate capacity readings, or premature beeping. We supply only genuine, factory-sealed Duracell 123A lithium cells with fresh expiration dates.

How to Change ZOLL AED Plus Batteries (Step-by-Step Reset Guide)

Replacing batteries in a ZOLL AED Plus requires following an exact sequence. You must press the internal reset button when prompted by the AED; otherwise, the device will continue chirping and maintain a red “X” indicator.

Installation & Reset Sequence

Step 1: Open the Battery Compartment

Place the AED face-down on a clean, flat surface. Locate the two pry slots on the rear battery compartment cover. Insert a coin or flat tool into the slots to release the retaining clips and lift the cover off.

Step 2: Remove All Old Batteries

Take out all 10 expired batteries from their slots and set them aside for recycling. Do not insert the new batteries yet.

Step 3: Observe the 30-Second Discharge Rule

Leave the battery compartment empty for at least 30 seconds. This allows the internal capacitor to fully discharge so the processor recognizes that a fresh battery set is being installed.

Step 4: Load the 10 New Duracell Batteries

Insert all 10 new Duracell 123A batteries into the slots, paying careful attention to the positive (+) and negative (-) polarity diagrams molded into each battery bay. Install the outer slots first, finishing with the center rows.

Step 5: Listen for Voice Prompt & Press the Reset Button

As soon as the final battery is seated, the AED will power on and issue an audible voice prompt:

“If new batteries, press button.”

Locate the small reset button inside the battery compartment well and press it firmly. The AED will confirm by announcing: “Batteries checked.”

Step 6: Verify the Green Status Indicator

Snap the rear battery cover back into place. Turn the AED over and check the status indicator window on the front handle. A green check mark (✓) indicates the unit has completed its internal diagnostic check and is fully rescue-ready.

Technical Specifications

Frequently Asked Questions

Do I need the ZOLL cardboard sleeve?

No. The cardboard sleeve is simply retail packaging. Inside the ZOLL sleeve are 10 standard Type 123 Duracell lithium batteries. Installing factory-fresh Duracell 123A batteries directly into the AED provides the exact same fit, performance, and 5-year operational life.

Why did my ZOLL AED Plus keep beeping after I changed the batteries?

If the reset button inside the battery bay was not pressed when the unit prompted “If new batteries, press button,” the AED assumes the old batteries are still in place. Remove the battery cover, press the reset button until the unit says “Batteries checked,” and verify the green check mark appears.

Can I replace only a few dead batteries instead of all 10?

No. Never mix old and new batteries or different battery types. All 10 batteries must be replaced simultaneously with fresh Duracell 123A lithium cells to maintain balanced voltage and ensure emergency reliability.